June 14th 2023

AtomOS 10.92.01 Firmware Release Notes

Ninja V


Installation Instructions:


ATOMOS recommends that your Ninja V is plugged into mains power before commencing the firmware update.

  1. Insert a compatible, formatted SSD into the Docking Station.
  2. Unzip the downloaded file and copy the ATOMNJV.FW file to the root of the HDD/SSD.
  3. Eject the SSD (according to operating system guidelines).
  4. Insert the SSD into the Ninja V.
  5. If you have an ATOMOS CONNECT accessory ensure this is connected to your device before powering on, as the module firmware will also need to be updated as part of this FW release.
  6. Power on the Ninja V and the firmware update process will begin automatically.
  7. If your Ninja V is already powered on, you will be prompted to perform the firmware update when a drive containing new firmware is inserted.
  8. Once the update is complete, your Ninja V will power itself down.
  9. Power your Ninja V back on and the device will automatically start updating the ATOMOS CONNECT accessory.
  10. To verify if the firmware update was successfully completed, navigate to the main menu and scroll to the info tab.

Note: Once firmware 10.92.01 is successfully installed on the Ninja V, the unit may reboot to update the ATOMOS CONNECT firmware. Do not interrupt the firmware installation process.

Bug Fixes & Improvements:


Improved audio quality when streaming to YouTube

Tweaked the device's RTMP audio configuration that may have previously caused distortion when streaming to YouTube.

Improved Panasonic LUMIX GH6 RAW signal locking

Resolved the issue introduced in AtomOS 10.92.00 that resulted in the Ninja V not locking incoming RAW signals from the GH6.

Known Limitations to be resolved in future releases: